IPC::Open2 - open a process for both reading and writing using open2()
- use IPC::Open2;
- $pid = open2(\*CHLD_OUT, \*CHLD_IN, 'some cmd and args');
- # or without using the shell
- $pid = open2(\*CHLD_OUT, \*CHLD_IN, 'some', 'cmd', 'and', 'args');
- # or with handle autovivification
- my($chld_out, $chld_in);
- $pid = open2($chld_out, $chld_in, 'some cmd and args');
- # or without using the shell
- $pid = open2($chld_out, $chld_in, 'some', 'cmd', 'and', 'args');
- waitpid( $pid, 0 );
- my $child_exit_status = $? >> 8;
The open2() function runs the given $cmd and connects $chld_out for reading and $chld_in for writing. It's what you think should work when you try
- $pid = open(HANDLE, "|cmd args|");
The write filehandle will have autoflush turned on.
If $chld_out is a string (that is, a bareword filehandle rather than a glob
or a reference) and it begins with >&, then the child will send output
directly to that file handle. If $chld_in is a string that begins with
<&
, then $chld_in will be closed in the parent, and the child will
read from it directly. In both cases, there will be a dup(2) instead of a
pipe(2) made.
If either reader or writer is the null string, this will be replaced by an autogenerated filehandle. If so, you must pass a valid lvalue in the parameter slot so it can be overwritten in the caller, or an exception will be raised.
open2() returns the process ID of the child process. It doesn't return on
failure: it just raises an exception matching /^open2:/
. However,
exec failures in the child are not detected. You'll have to
trap SIGPIPE yourself.
open2() does not wait for and reap the child process after it exits.
Except for short programs where it's acceptable to let the operating system
take care of this, you need to do this yourself. This is normally as
simple as calling waitpid $pid, 0
when you're done with the process.
Failing to do this can result in an accumulation of defunct or "zombie"
processes. See waitpid for more information.
This whole affair is quite dangerous, as you may block forever. It assumes it's going to talk to something like bc, both writing to it and reading from it. This is presumably safe because you "know" that commands like bc will read a line at a time and output a line at a time. Programs like sort that read their entire input stream first, however, are quite apt to cause deadlock.
The big problem with this approach is that if you don't have control
over source code being run in the child process, you can't control
what it does with pipe buffering. Thus you can't just open a pipe to
cat -v
and continually read and write a line from it.
The IO::Pty and Expect modules from CPAN can help with this, as they provide a real tty (well, a pseudo-tty, actually), which gets you back to line buffering in the invoked command again.
The order of arguments differs from that of open3().
See IPC::Open3 for an alternative that handles STDERR as well. This function is really just a wrapper around open3().